Inventronics offers wireless lighting control modules that enable any Inventronics Controls-Ready driver to operate on a vast array of lighting control networks via the 0-10V dimming input.  Inventronics Controls-Ready drivers power the wireless lighting controls module directly and can turn the driver output off electronically via the Dim-to-Off features-bypassing the power and voltage restraints associated with power packs and AC relays.  Anywhere from 120-480Vac and 40W-1200W, Inventronics has a wireless lighting controls solution for you.

This product has been discontinued The CSIM (Control Signal Integrating Module) is designed to integrate multiple signals (Dimmer, Occupancy Sensor, Ambient Light Sensor, RNTC, Remote control, Output Lumen Compensation, etc) into a 0-10V analog output and a
Signal Input: Multiple Input
IP Rating: N/A
The CNV-DMXR converts DMX signal to a 0-10V dimming signal. It complies with both DMX RDM and Traditional DMX networks. It uses the LED driver's Dim-to-Off capability to eliminate the AC Switch or Relay and is powered by the 12Vdc with a simple 3-wire connection to the driver.
Signal Input: DMX RDM or DMX 512
IP Rating: IP67
The CNV-SNAP-AN0 wireless network interface module that enables one or more Inventronics LED drivers to be controlled by Synapse Lighting Control networks. It uses the Dim-to-Off capability of Inventronics LED drivers along with their always-on auxiliary power to provide wireless connectivity at the lowest system cost. Its compact design and flexible deployment options make it ideal for both indoor and outdoor lighting systems and a wide array of luminaires.
Signal Input: Synapse
IP Rating: IP66
The CNV-ZIGB is a wireless dimming signal converter that enables one or more Inventronics LED drivers to be controlled by the Daintree Networks® ControlScope® building control solution. Using the CNV-ZIGB with other interoperable Daintree devices, Control
Signal Input: Daintree
IP Rating: N/A
This product has been discontinuedThe SDD-AAPNx works with Inventronics 0-10v dimmable drivers and is used to limit the maximum current output of the driver. Current limiting is accomplished by allowing the user to program a maximum 0-10v dim voltage.
Signal Input: 0-10V
IP Rating: IP66
DALI to 0-10v Converter.
Signal Input: DALI
IP Rating: IP66
This product has been discontinued. The SDD-APFNx converts a PWM signal to 0-10V signal. The output is relative to PWM duty cycle. The output is not related to the amplitude of PWM signal.
Signal Input: PWM
IP Rating: IP66
The TDD-ANFN-xxxx Dimmer is designed to work with 0-10V dimmable LED driver. The standard features include programmable dimming control, programmable soft start, factory setting and accurate time delay etc.
Signal Input: N/A
IP Rating: IP67
The TDD-ANPNx Dimmer is designed to work with 0-10V dimmable LED driver. The standard features include programmable dimming control, factory setting and accurate calibration etc.
Signal Input: PWM, Programmable Internal Timer
IP Rating: IP66
This product has been discontinued. The DALI controller can convert DALI command to control the LED lamp’s current via LED driver’s 0-10V interface, turn on or off LED lamp via internal switch. It complies with DALI protocol IEC62386-101,102,207 (2009 version).
Signal Input: DALI
IP Rating: IP67